Fronius IG 300 Manuel d'utilisateur télécharger pdf (Page 41)

- „IG no.“ ... Sets the number (=

address) of the FRONIUS IG in a

system with several interconnected

photovoltaic inverters

- To initiate „IG no.“ adjustment: Press

„Enter“ key (D)

(D)

(B)

Enter address (01 ... 99) (factory setting:

01)

- First digit flashing

- Use key (A) or (B) to select a number

for the first digit

- Press “Enter” key (D) to confirm

- Next digit flashing

(A)

(B) (D)(A)

- The procedure for entering the se-

cond digit is the same as for the first

digit (described above)

(D)

(C)

- Accept the IG no.: Press „Enter“ key (D)

- Restore previous setting: Press „Esc“ key (C)

NOTE! If several FRONIUS IGs are interconnected with a datalogger and data

communication is to be performed, then each FRONIUS IG should be assigned

a different address.

It is important to assign a different address to each FRONIUS IG to enable the datalog-

ger to distinguish between the individual inverters. If there are two FRONIUS IGs with

the same address in the system, then data communication with the datalogger will not be

possible. A different address should be assigned to any FRONIUS IGs on which status

message 504 appears.

Important! If your version does not have a display unit, information on how to set the

address can be found in the chapter entitled “Installation”, section entitled “Design

without display: Set address”.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 79 80

Pas de commentaire

Fronius IG 300 Manuel d'utilisateur Page 41