Fronius IG 300 Manuel d'utilisateur télécharger pdf (Page 20)

(4) Startup test

- Before the FRONIUS IG feeds power into the mains network for the first time,

the mains conditions are tested thoroughly in accordance with the relevant

national regulations.

- “START

” will appear on the display

The startup test can take anything from just a few seconds up to several minutes depen-

ding on national regulations. Progress is indicated by a vertical bar which reduces in

size from top to bottom.

Two of the previously flashing dividing marks disappear for every 10% of the total durati-

on of the startup test that has been completed.

Once the FRONIUS IG has been switched on automatically it carries out a self-test

routine. After this, the public mains network is tested.

This test can take from just a few seconds up to several minutes depending on national

regulations. During start-up the LED will appear yellow.

(1) Segment test

- All the display elements will be illuminated for approximately one second

(2) TEST

- Self-test of the FRONIUS IG’s main components

- The FRONIUS IG takes just a few seconds to run through a virtual checklist

- The display will show “TEST” as well as the component currently being tested

(e.g. “LED”)

Startup phase

(3) Synchronisation with the mains

- The display shows „WAIT

“: FRONIUS IG waits for all the power modules on

the mains to be ready. This procedure is dependent on the DC voltage.

- Next, the display will show „SYNC

“

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 79 80

Pas de commentaire

Fronius IG 300 Manuel d'utilisateur Page 20